Pile Testing Operation Steps and Example Analysis

How to get a good signal by low strain PIT dynamic test

The low strain PIT testing is to use a hammer to hit the top of the pile, and receive the stress wave signal from the pile through a sensor attached to the top of the pile.

What is Overcast Control? How to effectively control the Overcast height of cast-in-place piles?

What is concrete overcast? What are the problems caused by overcast?

Analysis of 9 common problems of pipeline robots

Before asking for assistance, the user can refer to this sheet first, and it may help you to find the solution.

Pipeline Inspection and Evaluation Result Table

Functional Evaluation of Pipeline

The calculation formula of pipeline operating parameter is similar to that of damage parameter, and it is just needed to substitute n as the number of functional defects of the pipeline.

CSL Testing Data analysis

Ultrasonic is a kind of elastic wave. The concrete medium is regarded as an elastic body. The propagation of ultrasonic waves in concrete obeys the law of elastic wave propagation.

Ultrasonic cross-hole testing method of pile foundation integrity

After the foundation pile is used to make holes and before the concrete is poured, embed a number of sonic logging pipes in the pile as the channels for the acoustic wave transmitting and receiving transducers.

Application Method and Description of Parallel Seismic Test

In the process of pile foundation inspection, besides the conventional underground pile foundation, it is sometimes necessary to inspect the length and integrity of foundation piles in deep foundation, foundation piles under bridge piers and existing buil

Description on the Application Method of Static Load Tester

The static load test method is recognized as the most direct and reliable test method for testing the bearing capacity of foundation piles and foundations.

Description on the Application Method of Borehole TV Imaging

The core-drilling method is a conventional detecting method and has been widely used in the detection of cast-in-place concrete piles.

Calculation of pipeline rehabilitation index

The structural defect type of pipeline is the reference value for making comprehensive definition of local defect or whole defect in evaluation of the pipeline.

Structural Evaluation of Pipeline

The parameter for pipeline damage condition is the calculation result of defect score, S is arithmetic mean value of the scores of each defect of pipeline, and Smax is the highest score among the scores of each defect of pipeline.

Pipe Crawler Robot Evaluation Basis and Method

This test and evaluation conforms to relevant provisions of Technical Specification for Inspection and Evaluation of Urban Sewer (CJJ 181-2012).

Ultrasonic testing of foundation piles Data analysis

Ultrasonic is a kind of elastic wave. The concrete medium is regarded as an elastic body. The propagation of ultrasonic waves in concrete obeys the law of elastic wave propagation.

RSM-SY6 UltraSonic Pile Integrity Tester Software features

The design of the main operating panel is similar to the traditional instrument appearance, and composed of four areas.

Introduction and application of cross sonic logging

As the basic device for defect testing of cast-in-place concrete piles, the ultrasonic pile integrity tester can generate repetitive electric pulses and excite the transmitting transducer.

What are the components of the static load test system?

Static load test equipment is mainly composed of loading reaction force system, load measurement system, displacement measurement system and automatic acquisition system.

Ultrasonic testing of piles for estimate abnormal phenomena and Analysis of the causes of defects

Ultrasonic transmission method is used as a method to detect the quality of foundation piles, which can accurately find the defect position and defect range of foundation piles.

How to use ultrasonic method to test the integrity of foundation piles

When the speed of sound, amplitude and PSD value exceed the critical abnormality or sudden change, the defect should be tested carefully.

Application range of high strain dynamic load method

Determining whether the bearing capacity of a single pile meets the design requirements is one of the main functions of the high-strain dynamic pile test method.